- 产品中心
- 联系我们
-
联系人：业务部 谭先生
手机号：18820179977
电话：0769-8326 7494
www.inchr.en.alibaba.com
www.inchrmaterial.com
-
产品名称：ESD C 1200 T-70D
订购热线：18820179977(微信同号)
产品说明：ESD C 1200 T-70D
Ether-based Thermoplastic Polyurethane Elastomer (TPUR/TPU)
Electrically Conductive
ESD Protection
PROPERTIES & AVERAGE VALUES OF INJECTION MOLDED SPECIMENS
PERMANENCEEnglish SI Metric ASTM
TESTSpecific Gravity 1.33 1.33 D 792 Molding Shrinkage 1/8 in (3.2 mm) section 0.0070 - 0.0150 in/in 0.70 - 1.50 % D 955
MECHANICALTensile Strength Die C, 0.125 in, 20 in/min (3.2mm, 500 mm/min) 4000 psi 28 MPa D 412 Tensile Elongation Break, Die C, 0.125 in, 20 in/min (3.2mm, 500 mm/min) 100.0 % 100.0 % D 412 Tear Strength, Die C 800.0 pli 140.2 N/mm D 624 Hardness Shore D, instantaneous 75 75 D 2240
ELECTRICALVolume Resistivity < 1E3 ohm.cm < 1E3 ohm.cm D 257 Surface Resistivity < 1E6 ohm/sq < 1E6 ohm/sq D 257
ESD STM11.11Surface Resistance < 1E5 ohm < 1E5 ohm ESD STM11.11 Static Decay MIL-PRF-81705D, 5kV to 50 V, 12% RH < 2.00 s < 2.00 s FTMS101C
4046.1PROPERTY NOTES Data herein is typical and not to be construed as specifications.
Unless otherwise specified, all data listed is for natural or black colored materials. Pigments can affect properties.
GENERAL PROCESSING FOR INJECTION MOLDINGEnglish SI Metric Injection Pressure 10000 - 20000 psi 69 - 138 MPa Melt Temperature 365 - 425 °F 185 - 218 °C Mold Temperature 100 - 140 °F 38 - 60 °C Drying 6 hrs @ 225 °F 6 hrs @ 107 °C Moisture Content 0.01 % 0.01 % Dew Point 0 °F -18 °C
PROCESSING NOTESDesiccant Type Dryer Required.
6 May 2011 SAC
This information is intended to be used only as a guideline for designers and processors of modified thermoplastics. Because design and processing is complex, a set solution will not solve all problems. Observation on a “trial and error” basis may be required to achieve desired results.
上一个产品：ESD A 2500下一个产品：ESD C 1200 T-85A
相关产品
